| Author |
Message |
Chris Deverson (Chris_prodrive)
Member
Username: Chris_prodrive
Post Number: 1
Registered: 6-2008
|
| Posted on Monday, June 23, 2008 - 4:18 pm: |
  |
Hi,
I was wondering if you had drawings for the pulleys you sell. I require the dimensions for the 20T and 30T pulleys. A sketch would be suitable.
Cheers |
Admin (Admin)
Board Administrator
Username: Admin
Post Number: 823
Registered: 10-2004
|
| Posted on Monday, June 23, 2008 - 8:59 pm: |
|
Chris,
Sorry but we do not have drawings, if there is a particular dimension you need, let us know. |
Naveb (Naveb)
Member
Username: Naveb
Post Number: 1
Registered: 11-2008
|
| Posted on Tuesday, November 18, 2008 - 9:03 am: |
|
Hi
Could you give me the internal dia of the brass insert on your pulley ,part number 4602-053
thanks Graham |
Admin (Admin)
Board Administrator
Username: Admin
Post Number: 929
Registered: 10-2004
|
| Posted on Tuesday, November 18, 2008 - 7:17 pm: |
|
Graham,
There is an introduction at the top of the 'Model Pulleys with Brass Hub' page which quotes the shaft size as 4mm (note that 4602-050 has an optional 2mm insert). |
Andrew S
Unregistered guest
|
| Posted on Sunday, February 21, 2010 - 7:04 pm: |
|
Width of pulley slot? What is the width of the pulley slot in your part "4602-054 50mm Model Pulley with Brass Hub"? I am looking for a pulley that will securly drive a thick 3mm diameter cord. |
Admin (Admin)
Board Administrator
Username: Admin
Post Number: 1212
Registered: 10-2004
|
| Posted on Wednesday, February 24, 2010 - 8:14 am: |
|
Andrew, good question, these pulleys are suitable for round belts up to approximately 3mm diameter. Website updated with this info. |
