Selected product filters Selected product filters

MOD 0.5 Gear Range

We stock MFA gears that are suitable for general use as well as for use with MFA Multi-Ratio Geared Motors.

Additionally we have Tbot MOD 0.5 gears that can be used in their own right or with the MFA MOD 0.5 gears.

The 2.9mm bore is an interference fit on 3mm shafts, the 3.1 mm bore is a slip fit on 3mm shafts thus allowing for multi-stage geared reduction stages to be built on a pair of axles. The pinion gears are intended for 2mm motor shafts.

Overall diameter measurements are nominal and in practice will be slightly under.

£0.24 (£0.29 incl VAT)
4600-008
12 Tooth, 7mm OD with 1.9mm bore.
In stock
+

£0.30 (£0.36 incl VAT)
4600-010
48/12 Tooth, 25 / 7mm OD with 2.9mm bore.
In stock
+

£0.30 (£0.36 incl VAT)
4600-011
48/12 Tooth, 25 / 7mm OD with 3.1mm bore.
In stock
+

£2.29 (£2.75 incl VAT)
4600-050
Contains 4 off 4600-011, 2 off 4600-010, 1 off 4600-008.
Out of stock
+

£0.15 (£0.18 incl VAT)
4600-070
Notes: Pinion gears sold individually but also available in packs of 10 upwards. A 10T pinion gear for an interference fit on a 2mm motor shaft. Nominal 6mm...
In stock
+

£0.17 (£0.20 incl VAT)
4600-071
A double gear with 30/10 teeth. OD 16/6mm, width 2.5/4mm, overall width 6.5mm. Intended as an interference fit on a 3mm shaft.
In stock
+

£0.15 (£0.18 incl VAT)
4600-072
A double gear with 30/10 teeth. OD 16/6mm, width 2.5/4mm, overall width 6.5mm. Intended as a slip fit on a 3mm shaft.
In stock
+

£0.18 (£0.22 incl VAT)
4600-073
A double gear with 50/10 teeth. OD 26/6mm, width 2.5/4mm, overall width 6.5mm. Intended as an interference fit on a 3mm shaft.
In stock
+

£0.18 (£0.22 incl VAT)
4600-074
A double gear with 50/10 teeth. OD 26/6mm, width 2.5/4mm, overall width 6.5mm. Intended as a slip fit on a 3mm shaft.
In stock
+