Hardened & Chromed Steel Rod 8mm x 400mm

£6.59
(£7.91 UK, incl VAT)
4427-084
165 g
In Stock
+
Add to wish list

A chromed and induction hardened C1045 carbon steel rod / bar. You will struggle to cut to length with an ordinary hacksaw so best to use an abrasive cut off say. It's just the surface that has been case / surface hardened so once you are through that, the going gets easier.

These hardened bars are intended for use with linear bearings where if you use silver steel for example, the hardened ball bearings will quickly score the surface of the bar.

Customers also bought....

4427-085
£6.65 (£7.98 UK, incl VAT)
4427-085
A chromed and induction hardened C1045 carbon steel rod / bar. You will struggle to cut to length with an ordinary hacksaw so best to use an abrasive cut...
In Stock

4604-208
£0.99 (£1.19 UK, incl VAT)
4604-208
From our Makertronics branded range of products at Everyday Low Prices. A pillow style aluminium mount for round guide rails of 8mm diameter as...
In Stock

4604-608
£0.70 (£0.84 UK, incl VAT)
4604-608
From our Makertronics branded range of products at Everyday Low Prices. A linear slide bush for 8mm hardened steel shafts. Overal Diameter:...
In Stock

6001-093
£1.47 (£1.76 UK, incl VAT)
6001-093
A GT2 smooth idler pulley with a pair of bearings fitted. Suitable for use with our GT2/2GT rounded tooth profile timing belts. Teeth: None...
In Stock

6002-591
£13.38 (£16.06 UK, incl VAT)
6002-591
A 2mm pitch, 2500 tooth (5000mm long), 10mm wide fibreglass reinforced 2GT (also referred to as GT2) open rubber timing belt. Commonly used on small CNC...
Out of stock