Any Other Support Questions

Have a general question that does not relate to a specific product or any of the other general questions pages above but still relates to our product range, then post your question here (see 'New Post' link at the bottom of the page) and we will do our best to answer it.

Comments

Mike,

Your message some how got lost. A 2.9mm bore is what is called an interference fit. This basically means it is a very tight fit so it grips the shaft. It is not intended for free spinning on the shaft.
What is the procedure to fit a 2.9mm bore gear to a 3mm shaft? I would appreciate advice.
Petri,

They are as per the product description, ID 3.2mm OD 5mm, length 8mm.

Regards
Can you confirm the measurements of these washers (OD, ID, length)? https://www.technobotsonline.com/nylon-spacer-8mm-pk-of-25.html (page says they are M3)
Tom,

Best to use the FAQ tab on the product for the quickest response.

In answer to your question, no because as per the description, the internal diameter of the groove is only 8mm so is likely to break through or leave a paper thin wall thickness.
Can the pulley part # 4602-014 be made with 8mm pitch (shaft diameter)?
Thank you
Dear Zahid,

If you click on the 'contact us' link in the footer, there is a form there to which you can add attachments. We will only complete supplier forms for UK based educational establishments.

Regards

Support
can you give me an email so I can send you a new supplier form
Andrew,

If the 30A is the nominal current drawn at full load at 24V then that is a power draw of 720W. Assuming an efficiency of 65%, that gives a motor power of 468W which sounds more like it.

I would suggest the the sabertooth dual 60A controller 1506-009. That should handle the acceleration and reversing currents well.
Sorry Paul- I meant 30 amps! Apologies for the delay in replying, that work thing got in the way!
Write a review