3 to 1 ratio

Technobots FAQ » Transmission (Bearings, gears, sprockets & wheels) » 3 to 1 ratio « Previous Next »
Author Message
martin jakubait (Hati123)
Member
Username: Hati123

Post Number: 2
Registered: 7-2009
Posted on Wednesday, July 8, 2009 - 4:15 pm:    Edit Post    Move Post (Moderator/Admin Only)

Hi thank you for your last input, what i have is a motor with a 6mm shaft and a tail shaft in my bait boat with a 5mm shaft i need to turn the shaft at least 3 times faster than the motor, can you recomend either aluminium pullys, or timing belt pullys with belts, i have facilitys for boring out bigger holes, i would like to use some sort of pully system to keep the noise down. if you could supply part no i will be very gratfull thanks very much martin
Admin (Admin)
Board Administrator
Username: Admin

Post Number: 1080
Registered: 10-2004
Posted on Wednesday, July 8, 2009 - 6:35 pm:    Edit Post    Move Post (Moderator/Admin Only)

Can you advise the motor power and the motor rpm please.
martin jakubait (Hati123)
Member
Username: Hati123

Post Number: 3
Registered: 7-2009
Posted on Thursday, July 9, 2009 - 12:12 pm:    Edit Post    Move Post (Moderator/Admin Only)

hi i new you were going to ask that, i bought these motors in bulk, and the company is no longer, i dont no the RPM but i do run them on 24v to get the max RPM, the boats are all wired 24v; lights, solinoids ect. I hire these bait boats out and would gladly buy replacments from you, is there some were i could send you one of the motors so you could test and advise, each boat has two motors, we do use all your speed controllers ect in our boats, they are very torque, they have to be,each boat carries 9 kilo of bait and they can chop there selves out of weedy situations. I would rather up the rpm on the motors than have a gear box. thanks very much martin
Admin (Admin)
Board Administrator
Username: Admin

Post Number: 1083
Registered: 10-2004
Posted on Tuesday, July 14, 2009 - 7:44 am:    Edit Post    Move Post (Moderator/Admin Only)

Without the rpm and power figures we are unable to recommend a suitable motor and timing belts as belts have a limited maximum speed. You will need to measure the rpm and current drawn, then we should be able to help.