The kit has four buttons and LEDs to make up a game, which can be used as both a memory game and a reactions game. A PIC micro-controller, pre-programmed with special software controls the game. The on / off switch and battery pack mount directly onto the board allowing it to be used as built or the game can be housed into an enclosure.
This kit includes:
- 1 x 2AA battery holder (PCB mount)
- 6 x 680ohm resistors
- 1 x 47ohm resistor
- 1 x 5mm red LED
- 1 x 5mm green LED
- 1 x 5mm yellow LED
- 1 x 5mm orange LED
- 4 x 6mm PCB mount switch - height 9.5mm
- 1 x PIC 12F675 pre-programmed with game code
- 1 x 8 pin IC holder
- 1 x right angled PCB mount switch
- 1 x M3 nut and bolt
- 1 x game PCB
PCB dimensions: 58.5mm x 58.5mm.
Requires x2 AA batteries
This kit is supplied in a simple grip seal bag without printed instructions.
No posts found
No FAQ found