The kit has seven LEDs that are used to display a random dice number every time the ‘start’ button is pressed. A PIC micro-controller, pre-programmed with special software controls the dice.
The ‘start’ switch mounts directly onto the board allowing it to be used as built or the dice can be housed into an enclosure.
The kit includes:
- 1 x PP3 clip lead
- 1 x 3AA battery holder
- 7 x 5mm red LEDs
- 7 x 330ohm resistors
- 1 x 6mm PCB mount switch - height 9.5mm
- 1 x PIC 12F508, pre-programmed with dice code
- 1 x 8 pin IC holder
- 1 x dice PCB
PCB dimensions: 66mm x 39.5mm.
Requires x3 AA batteries, available separately.
This kit is in a simple grip seal bag without a printed set of instructions.
No posts found
No FAQ found