COVID-19 (Coronavirus) update: Whilst we are continuing to ship customer orders, same day dispatch is not guaranteed. Lead times for out of stock / back order and non-stocked items are increasing due to our suppliers operating with reduced staffing levels. International deliveries - please allow extra time for your order to arrive with delays in the transport network worldwide. Some countries have suspended their internal postal system so please check with your local postal service before ordering. Royal Mail is unable to guarantee its UK Next Day Special Delivery service.
The switch is on the "bottom" side, where you put in the batteries. So you can't just glue/screw/fix the module to a piece of board or something, like I expected :-( Will have to figure out some other way to use these now. Looking at the photos again, I could have spotted this but I just expected the whole thing to be mountable onto a surface and then still use the switch. So be warned.
Asked by Joost Leeuwesteijn | 08/11/2012, 13:05 | 0 answer(s)
What is the voltage output? Because I need it to be able to power the bi-directional motor controller.
Asked by Philip Panchenko | 17/08/2011, 11:34 | 1 answer(s)
This is simply a battery holder, you need to provide your own batteries. The voltage out will be 4 x the individual battery (cell) voltage. If you use say Alkaline batteries, these are normally about 1.61V when new and with no current load, so 4 will give 6.44V