Testimonials Testimonials

3D Printer Limit Switch Module with Lead

1.18
(1.41 incl VAT)
7110-002
In stock
+

A microswitch based limit switch module for use when detecting end of travel on your 3D printer or other X, Y, Z platform. Supplied ready assembled with pull up resistors and on-baord LED plus includes a 600mm long lead.

This board is based on the makerbot v1.2 design. The three wires are

Red +5V

Black 0V (ground)

Green Signal Output (+5V when switch not made, 0V when switch operated)

No FAQ found

Customers also bought....

1064-102
0.60 (0.72 incl VAT)
1064-102
This 6" (15cm) cable has two 26AWG stranded conductors with a 2.5mm-pitch 2-pin female JST XH-style connector. The spacing is very close to 0.1", which...
In stock

3801-185
1.01 (1.22 incl VAT)
3801-185
The LT positive temperature coefficient temperature sensing resistor is trimmed to specification on latest equipment. The case construction is epoxy coated...
In stock

7110-010
0.42 (0.51 incl VAT)
7110-010
This 100k thermistor is commonly used in 3D printers as the temperature sensor for the nozzle. With a 1.7mm body diameter and a length of just 3.2mm makes...
In stock

7110-101
6.72 (8.07 incl VAT)
7110-101
Many 3D printers are now moving from T2.5 pitch timing pullys / belts to GT2. This set includes two 20 tooth pulleys and 2 metres of open length belt. This...
Out of stock

7110-103
1.85 (2.22 incl VAT)
7110-103
Many 3D printers are now moving from T2.5 pitch timing pullys / belts to GT2. A common size pulley is this 20 tooth (we also have 16 tooth pulleys and...
Out of stock