Author |
Message |
calum (Calumco) Member Username: Calumco
Post Number: 1 Registered: 6-2008
|
Posted on Monday, June 23, 2008 - 8:35 pm: |
|
i recentally sent you a message regarding problems with the Sabertooth Dual 10A Motor Controller- i said that when i used it the robot would be working fine then i would just loose all control and it would start doing the opposite to what i just made the robot do e.g if i turned to the right it would just turn left on its own and then i would have to turn off the power and then turn it back on again to regain control . im using 2 - 9.6 volt motors running off 2 - 9.6 volt drill batteries connected in paralell and im using a futaba 2.4 ghz control system, i thought i would send this again because i havn't heard anything for a week. if you could reply on this message board that would be best. Kind regards Calum Jones |
Admin (Admin) Board Administrator Username: Admin
Post Number: 824 Registered: 10-2004
|
Posted on Monday, June 23, 2008 - 9:06 pm: |
|
Hi Calum, Can you set switch 4 to the down position and try again please. Sorry for the delay in replying, it was an over-sight. |
calum (Calumco) Member Username: Calumco
Post Number: 2 Registered: 6-2008
|
Posted on Wednesday, June 25, 2008 - 10:07 pm: |
|
hi, It seems to be working now, i've been having a play around with it and it hasn't gone crazy yet, i just did what you said and flicked switch 4 down. Thanks for the help, kind regards calum |
|