General Mechanical Questions

"Good afternoon,

I'm so pleased I found a supplier local to me!!!

I'm looking for the following items, and I was wondering if you would be able to help:

4 x .079" OD pulleys, .08 pitch

2 x 2.5" Handwheel

2 x .080" pitch 77" outer circle timing belt

4 x 1/4" stainless steel drive shafts

2 x 1/4" bore shaft collars

4 x PEEK flanged sleeve bearings for 1/4" shaft

4 x 3/8" ID bearing blocks

16 x 1/4" Aluminium spacers

16 x no 10 - 24 1" Machine screws

4 x no 10 - 24 1/2" Machine screws

8 x plastic bushings (to allow 1/4" shaft to fit into 3/8" bearing block)

I needs these items quite urgently. I'm constructing a prototype, and would require large numbers of the above in the future.
I look forward to hearing from you.

I look forward to hearing from you.

Very best wishes

Dave"

– Dave

"Im after MXL 0.080" pitch pulleys with the following specs:

12 tooth 5mm bore
48 tooth 12mm bore

Aluminum or steel."

– George

"I'm trying to achieve a motorised camera mount.
Basically a vertical rod (about smartie tube size) where the top half will turn left & right slowly on it's own. Do you have something of this description or materials so i can make it?
Thanks"

– martin

"do you sell a plastic or metal crankshaft that turns rotation into horizontal push pull opration over about a 1inch movement? "

– tom bach

"RE: http://www.technobotsonline.com/timing-pulley-14t.html

Is this a standard 'XL' series timing pulley (5,08 pitch)?
If so, can the pilot hole be bored out to 8mm?

Regards,
Dave."

– Dave