Bosch 400

Technobots FAQ » Motors » Bosch Motors » Bosch 400 « Previous Next »
Author Message
andrew kenworthy (Teamkenny)
Username: Teamkenny

Post Number: 1
Registered: 5-2006
Posted on Tuesday, May 2, 2006 - 10:35 pm:    Edit Post    Move Post (Moderator/Admin Only)

hi, paul

do you still have the bosch 400's

or can you get them??

or where did you get them before and how much was they??
Admin (Admin)
Board Administrator
Username: Admin

Post Number: 233
Registered: 10-2004
Posted on Thursday, July 6, 2006 - 9:24 pm:    Edit Post    Move Post (Moderator/Admin Only)

Hi Andrew

Sorry but missed this post completely. We have not supplied the Bosch 400 for years as they were not popular as most users went for the Bosch 750W which we still supply. We may still be able to get them, how many do you need?

If you need to work out the distance between centres of any two timing pulleys, then this calculator will eliminate the long calculations or trial & error for you.



  Timing Pulley Distance Between Centres Calculator  
  Large Pulley Teeth Number T  
  Small Pulley Teeth Number T  
  Pitch   mm  
  Belt Length   mm  
  Large Pulley PCD   mm  
  Small Pulley PCD   mm  
  Distance Between Centres mm  
  How to use the Pulley Distance Calculator  
  1. Enter the number of teeth on the largest pulley  
  2. Enter the number of teeth on the smallest pulley  
  Note: if 1:1 ratio, enter the same number of teeth in both boxes  
  3. Enter the belt tooth pitch in mm, i.e. T5 is 5mm, T2.5 is 2.5mm  
  4. Enter the belt length in mm  
  The resulting answer is shown in the bottom yellow box. For information, the PCD of the pulleys is also shown in the other yellow boxes.  
  In order to achieve the correct tension, one of the pulleys should be adjustable.  
  Disclaimer: Whilst we have taken evey care to ensure this calculator gives the correct answer, Technobots cannot be held responsible for any errors and their consequencies.