Any Other Support Questions

Have a general question that does not relate to a specific product or any of the other general questions pages above but still relates to our product range, then post your question here (see 'New Post' link at the bottom of the page) and we will do our best to answer it.

Comments

Richard,

Sorry but we have never stocked EMD motors or their spares. Best bet if you already haven't done so is to contact EMD direct.
I am looking for a replacement brush holder for an early EMD unit, can you help or direct me please? I have photos of the item if it helps.
Gareth,

We only have what is listed on our website. 4mm shaft is rather small for such a large gear, we would suggest 6mm minimum. I would suggest sleeving a 6mm bore down to 4mm although I see that we do not stock a 50T MOD 1 gear. However, we do have some on order but will again be 6mm bore.
is it possible to get a steel spur gear mod 1 50tooth with 4mm bore size ? also need 12 tooth steel with 4mm bore ,we have plastic ones from you but need steel
K J,Sorry but we do not have planetary gear boxes although we do stock planetary geared motors.
I need a simple Planetary gear assembly to use for an exhibition. Preferably with a triangle holding the outer gears and a large outter gear. Do you have the parts or kit to do this?thanks in advance.
Frank,If you search for rudder in the search box above you will see that the third item of 3 is for the pre-programmed chip.
Hi,Are you able to supply the components to complete the Rudder Mixer by Alan Bond, please? I cannot seem to locate the pre-programmed IC.Many thanks,Frank
Bill,We do not manufacture gears in-house but get them made for us. We are unlikely to be competitive for such large volumes and suggest you consider the far east.
We have some gears that need to be made or ordered that we need in quantities of 10,000 to 100,000/ yr. How do we get the drawings to you?
New post