Technobots General Support

Any Other Support Questions

Have a question that does not relate to a specific Technobots product, then post your question here and we will do our best to answer it.

Comments

17/06/2013, 12:44

"Andrea,

You need your user name, from there you can do a lost password. I have checked on your user surname with three matches but none of them are you.

I could not find any previous orders in your name either so it sounds like you have not registered before or placed an order in a different name or checked out as a guest.

Either check any previous orders for the order name and let us know or set up a new user account."

– Admin

17/06/2013, 11:53

"We have an account with you, however, the login/sign in details are unavailable. How do I access this information?
Thanks for your help."

– Andrea Daly

11/06/2013, 21:42

"Terry,

Please post your question again under the Q&A tab of the product you have the query about and we will try and answer it. We have 8,000+ products and we need to be sure that we are talking about the same product plus it makes it easier for others to see any questions relating to the same product.

Thank you"

– Admin

11/06/2013, 20:55

"PIR sensor - Please could you explain the copy below from your web site, as I don't understand.

"The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. If any of the motion sensors go off, the input pin will be pulled low.
The connector is slightly odd but has a 0.1" pitch female connector making it compatible with jumper wires and 0.1" male headers.
Regards Terry
"

– Terry Rowe

14/05/2013, 13:51

"Burgess,

They are the belt length / circumference as they are based on the number of teeth x belt pitch. "

– Admin

14/05/2013, 12:52

"The answer may obvious, but I'll ask anyway.
Timing Belts:
Are the measurements given for the length, the full circumference?

Burgess"

– Burgess Evans

04/05/2013, 18:32

"Arttu,

Hard to tell from your description but take a look at 1503-045 Pololu Controller as that might do the job. The servo controller you linked to is certainly not suitable and is a different product / application altogether."

– Admin

04/05/2013, 14:47

"I got a 24 Vdc proportional valve with a broken controller card. I would use it in a project if I could find a suitable controller. It is controlled by turning a 10 k pot and the position feedback is also a 10 k pot. Do you have a suitable ready PCB for this? Like a http://www.technobotsonline.com/pot-servo-controller.html but with 24 V /0,2 A."

– Arttu Piironen

22/04/2013, 10:18

"Andreas,

Sorry but not to our knowledge so we have just removed this product from our site.

"

– Admin

22/04/2013, 08:10

"Hi!
Will the RooStick (Item # 8000-667) be available in the next future?
Thanks!"

– Andreas

Pages: 1 2 3 4 5 6 7 8 ...